Filter
Top Products
C1307M-C (8/07) 15
OPERATING NOTES
ENVIRONMENTAL RANGE
The operating temperature ranges from a minimum of -40°F (-40°C) to a maximum of 131°F (55°C) for sustained system operation or 140°F (60°C)
absolute maximum. The entire unit can de-ice and be operational in two hours from a temperature of -13°F (-25°C). The electronically controlled
window heater consumes a maximum of 10 W and operates at temperatures of 59°F (15°C) and below.
PAN/TILT FUNCTIONS
TURBO MODE
Turbo mode lets you pan left or right at either 100° per second (50 MPH) or 50° per second (90 MPH). Some controllers have a turbo mode button;
others switch to turbo mode if you hold the joystick at either full right or full left. Refer to your controller documentation for the appropriate steps.
SCAN SPEED
Scan speed is adjustable from 1 to 40 degrees per second through the programming menu.
PRESET FUNCTIONS
The Esprit system is capable of going to 80 preset locations, each with a 20-character label. The presets are numbered 1-32 and 35-82. Refer to
the documentation for your control system for programming presets.
If you command the pan/tilt to go to an undefined preset, erratic operation may result.
Presets 33 and 34 are fixed commands, meaning that you cannot program them. Preset 33 is the “flip” command, which will pan the system
180 degrees. Preset 34 is the “pan zero” command, which will pan the system to the factory-determined zero reference point.
RANDOM, FRAME, AND AUTO SCANNING
Select preset 97 (30) to start random scanning. Select preset 98 (31) to activate frame scanning (three seconds of scanning followed by a three-
second pause). Select preset 99 (32) to start auto (continuous) scanning. Scan limit stops are controlled by software. Refer to Limit Stops on
page 32 to program the scan limit stops.
When the pan/tilt reaches a scan limit stop, it reverses direction. Select preset 96 (29) to stop a scan. Any pan/tilt or lens command will also stop
a scan.
NOTE: The number in parentheses represents the preset for controllers with 32 presets.
ZONES
A zone is a programmed pan area with set boundaries and identifying label. The Esprit system has a maximum of eight zones, each with a
20-character label. Zones can be programmed to blank video when the camera pans into the zone area. If a zone is blanked, the system displays
VIDEO BLANK. (Refer to Zone Blank on page 49 for more information.)
Controller
Type
Pan
(Capability: 360° Continuous Pan Rotation)*
Tilt
(Viewing Range: +33° to -83°)
†
Fixed speed Speed determined by controller Speed determined by controller
Variable speed
Turbo Mode
‡
Preset Mode
‡
0.1° to 40° per second, depending on joystick position
100° per second (50 MPH); 50° per second (90 MPH)
100° per second (50 MPH); 50° per second (90 MPH)
0.1° to 20° per second, depending on joystick positions
Does not affect the tilt speed
30° per second
*If manual limit stops are set, Pan limit appears on your monitor when a limit stop is reached (except when you are programming or running a
pattern). This does not apply to scan limit stops.
†
When the system reaches the upper limit, Tilt limit appears on your monitor (except when you are programming or running a pattern).
‡
The unit supports two wind speed profiles: 50 MPH and 90 MPH (for more information, refer to Speed Profile on page 47).