Napco Security Technologies GEM-P3200 Home Security System User Manual


 
L NAPCO Security Systems
X GEM-P3200 Programming Instructions
Page 53
WI818G 10/05
ACCESSING USER PROGRAM MODE
1. Press EEEEEE R
2. Press Q Until ACTIVATE PROGRAM Y/N appears on LCD screen.
3. Press P To Enter User Program Mode
4. Press C To Exit User Program Mode when finished
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
USER CODES
Up to 48 User Codes may be programmed.
NOTE: In this mode, only the code is pro-
grammable; the accompanying Area Options
must be programmed in the Dealer Program
Mode. By default, User 1 is enabled in Area 1
and 2; Users 2-8 are enabled in Area 1, Users
9-16 are enabled in Area 2; Users 17-48 are
not enabled in any areas (see page 10).
Use the R button to place the cursor
over the User Number.
Enter a User Number (01–48) using the number buttons. The cursor will then advance to the User Code and read the existing
code, if any.
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press
G 0 button.
Press the U button to save the code in memory.
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT button or the PRIOR but-
ton.
GEM-K1CA Keypad (Direct Entry)
Enter user code
U01 123
USER PROGRAM MODE
Programming User Codes with GEM-K1CA Keypad
To Program User Codes
1. Set Cursor Position using the
R button.
2. Enter 2-digit User Number (01-
48) directly using number but-
tons (0-9).
3. Enter Code (1-6 digits) directly
using number buttons (0-9).
4. Press the
U button to save
each code.
NOTE: Press G 0 button to clear character at cursor.
To continue press P or Q button.
GEMINI
Enter user code
U01 123 - -
A
R
M
E
D
COMPUTERIZED SECURITY SYSTEM
S
T
A
T
U
S
R 1 2 3
B 4 5 6
C 7 8 9 0
U
NEXT/YES
P
PRIOR/NO
Q
AREA
G
User Code
NOT USED