Filter
Top Products
X GEM-P3200 Programming Instructions
L NAPCO Security Systems
Page 48
WI818G 10/05
EXTERNAL RELAY CONTROL
EXTERNAL RELAY CONTROL
STEP 2: AREA OPTIONS: Each relay/entry can be assigned to Area 1 or 2 or both areas.
Select the area from Table 2 (shown on next page); enter in corresponding left and right digit
address locations.
RELAY EVENT OPTIONS
RELAY # AREA Timeout Event ID COND.
L R L R
L R L R
(•)
(•)
To program, follow the 5 steps below:
STEP 1: RELAY # OPTIONS: Each relay/entry can be assigned to any of the
24 available external relays from Relay Module RM3008. Multiple entries can
drive the same External Relay.
Select the relay number from Table 1 (shown on next page); enter in
corresponding left and right digit address locations.
Note: Entries 01-24 correspond to relays 1 through 24. If entries are zero, zero
(00), then relay number is identical to the relay/entry address table number, in
the selected address table(s) above.
STEP 3: TIMEOUTS: Each relay event can be assigned a timeout depending on Alarm Type option.
If Alarm Type is selected for timeout in minutes or seconds, enter the 3-digit timeout duration in corre-
sponding address location. To choose seconds or minutes, see step 5A below. 254 is maximum entry.
Continued
STEP 4: EVENT ID CODES: Each relay event can be assigned any of the available event IDs from the table.
Select 2-digit Event ID from Table 4 (see page 50); enter in corresponding address locations (left and right digit).
STEP 5: RELAY EVENT CONDITION OPTIONS: Each relay event can be assigned an alarm type; and an activation
condition; also, select a timeout type for each.
5A. Select Alarm Type and Timeout Type from Table 5A (see page 51); enter in corresponding address location (left digit).
NOTE: Select Timeout from Step 3.
5B. Select Activation from from Table 5B (see page 51); enter in corresponding address location (right digit).
Step
4
Step
5
Step
1
Step
2
Step
3