Filter
Top Products
X GEM-P3200 Programming Instructions
L NAPCO Security Systems
Page 52
WI818G 10/05
DIRECT ADDRESS PROGRAM MODE--USER PROGRAM MODE
USER PROGRAM MODE
PRELIMINARY INFORMATION
The User Program Mode is covered in detail in the operating instructions for the keypad in use.
Only Keypad #1 may be used for programming, however this keypad may be located in either area.
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-
up.
After entering codes or data, press the save U button. Data will not be stored into memory unless this button is pressed.
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
Press the C button to silence the sounder and exit the User Program Mode.
If a GEM-RP2ASe2/GEM-K2AS keypad is used, configure address jumpers as Keypad #1 (See WI1184).
NOTE: For ease of programming, it is recommended that a GEM K1CA (or GEM-RP1CAe2) be used as Keypad #1. A new GEM-
K1CA and a new GEM-RP1CAe2 are automatically configured as Keypad #1. See Keypad Configuration Mode.
SYSTEM RESET OPTIONS (ADDRESS 4091-4093)
Clear Dealer Program (Erases Dealer Program)
This erases the dealer program. Use this feature to start
a customized default program.
Access address 4091, then press the
J or U button. Data entry is not
allowed.
NOTE: Enter Easy Menu Driven Program Mode to program system
again.
GEM-RP1CAe2/GEM-K1CA Keypad
4091 XX
GEM-RP2ASe2 Keypad
4091XX
Cold Start (Erases Entire Program)
This erases the entire program (codes, schedules,
foreign language configuration, etc), leaving the panel
as it came right out of the box.
Access address 4093, then press the
J or U button. Data entry is not
allowed.
NOTE: Some features (schedules, language configuration) can only be
re-programmed with the Downloading Software.
GEM-RP1CAe2/GEM-K1CA Keypad
4093 XX
GEM-RP2ASe2 Keypad
4093XX