Filter
Top Products
Then press the ENTER key. Your computer will respond:
Bad command or filename
A>
Default Drive
MS-DOS will only look at one disk drive at a time. Normally,
this is the “default” drive. You can tell which disk drive is the
current default drive by looking at the system prompt.
For example:
indicates that the “A” drive is currently the default drive.
Unless you specify otherwise, MS-DOS will direct any disk
activity to the “A” floppy disk drive.
You can easily change the default drive with an internal DOS
command. For instance, to change from the “A” drive (floppy
disk), to the C drive (hard disk), enter:
The computer will respond:
4-10 Using MS-DOS With Your Computer