Filter
Top Products
The computer responds with:
Write data into CMOS and exit (Y/N)?
Press Y. The computer will update the information in its
configuration RAM, and will go through the start-up routine
again. Make sure MS-DOS is installed on floppy disk or hard
disk of your system, so the system will boot up in MS-DOS.
Note
Your system has an on board IDE type HDC and if you
want to install the another type of HDD except IDE, you
must disable the on board IDE HDC using the Extended
Setup Program. See Chapter 2 for the detailed information
of it.
Partitioning Your Hard Disk
After the DOS Shell screen appears, select the Command
Prompt option.
At this point your are ready to partition your
hard disk drive.
To do this, enter the command:
A > FDISK
After loading the FDISK program, the computer will display
information on the hard disk drive installed in the system, as
follows:
6-6
Using Your Hard Disk