Filter
Top Products
-
5
-
Instructions on wiring
!
WARNING
1. When the drive is connected to power, connect it via a line-protection molded case
circuit breaker or an earth-leakage circuit breaker (Residual current operated
protective device).
Otherwise, fire could occur.
2. Be sure to connect the ground wire,
otherwise electric shock or fire could occur.
3. Ensure that a licensed specialist
performs the wiring work.
4. Check before starting the wiring that the power is off (OPEN),
otherwise electric shock could occur.
5. Do not wire up the drive until it has been installed securely,
otherwise electric shock or injury could occur.
6. The drive has to be grounded in accordance with the national and local safety
specification
otherwise electric shock could occur.
!
CAUTION
1. Check that the number of phases and the rated voltage of this product correspond to the
number of phases and voltage of the AC power supply,
otherwise fire could occur.
2. Do not connect the AC power supply to the output terminals (U, V, W),
otherwise injury could occur.
3. Check the output terminals (U,V,W) for the phase order and connect them to the motor
correctly,
otherwise fire could occur.
4. Do not connect a braking resistor directly to the DC terminals [P(+), N(-)],
otherwise fire could occur.
5. Noise is generated from the drive, motor, and wiring. Take care that this noise does
not cause malfunctions in peripheral sensors and equipment,
otherwise accidents could occur.