Filter
Top Products
Change during operation: N = impossible, Y* = possible (enabled by using ),
Y
= possible (enabled by using
)
-
52
-
FUNC
DATA
X1 terminal function
X2 terminal function
X3 terminal function
0
Multistep frequency selection 1 (SS1)
1
Multistep frequency selection 2 (SS2)
f1 : Frequency selected with F01
(keypad panel/analog/freq. setting POT )
f2 : Frequency selected with C05
f3 : Frequency selected with C06
f4 : Frequency selected with C07
OFF input is assumed if SS1 or SS2 is not selected.
2
Coast-to-stop command
Drive output is cut when the BX terminal is connected to the CM terminal.
OFF input is assumed when BX is not selected.
3
Alarm reset (RST)
The alarm output is released between the RST and CM terminals when power is turned on.
The trip status is released between the RST and CM terminals when power is turned off.
(Refer to 6-2 Alarm Reset on page 60)
4
External alarm (THR)
Drive trips with OH2 when the THR terminal is disconnected from the CM
terminal.
ON input is assumed when THR is not selected.
5
Write enable command for keypad(WE-KP)
Function change from the keypad panel is disabled when the WE-KP terminal is disconnected
from the CM terminal.
Function change from the keypad panel is enabled when the WE-KP terminal is connected to the
CM terminal.
ON input is assumed when WE-KP is not selected.
6
PID control cancel (Hz/PID)
PID control operates when the Hz/PID terminal is disconnected from the CM
terminal and does not operate when they are connected.
OFF is assumed when the Hz/PID is not selected.
Hz/PID is valid only when function
H 2 0
is set to
1
or
2
.
(PID control operation).
f3
f2
f1
FWD-CM ON
(SS1)-CM ON ON
(SS2)-CM ON
Factory
setting
Change during
operation
0
N
E01
2
N
E02
3
N
E03
E01
E02
E03
t
Output
frequency
f4