Filter
Top Products
Change during operation: N = impossible, Y* = possible (enabled by using ),
Y
= possible (enabled by using
)
-
53
-
FUNC
DATA
7
Link operation selection (LE)
Operation setting can be done by commands from RS485 when the LE terminal
is connected to the CM terminal.
A command from RS485 is ignored when the LE terminal is disconnected from
the CM terminal.
ON input is assumed when LE is not selected.
LE is valid only when function
o 0 0
is set to
1
(option operation).
Note: Set function
E 0 3
to a value from
0
to
3
when using the X3 terminal
as a PLC terminal (SW7 is set to PLC).
Continued from previous page