Filter
Top Products
190-01007-A1 System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
Rev. 7 Page 6-28
In the event of a bonding test failure, remove the bonding strap from the aircraft ground point and clean the
attachment point with a bonding brush. Re-install the bonding strap and perform the electrical bonding test
in accordance with Section 4.5 again.
Figure 6-15. Flight Stream Bonding
Table 6-8. Flight Stream Bonding Hardware
See Figure 6-15 Hardware P/N
1 Screw AN515, AN515B, or AN515C
2 Lock washer MS35338-137
3 Flat washer NAS1149CN832R or AN960C-8
4
Terminal Lugs (7 AWG or 10 AWG
depending on size of braid)
MS25036
5 Screw MS51957-42
6 Braid
QQB575R36T0250
3
31
2
4
5
2
46
3