Filter
Top Products
190-01007-A1 System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
Rev. 7 Page 6-5
6.2 GMA 35
Removal
1. Locate and pull the audio panel circuit breaker
.
2.
Ensure that the GTN(s) are not receiving power prior to removal of the audio panel.
3. Remove the GTN 7XX.
4. Locate the GMA 35 unit retention mechanism access hole at the bottom center of the unit face.
5. Insert a 3/32" hex tool into the access hole and turn the fastener counterclockwise until the unit
is
fo
rced out about 3/8" and can be freely pulled from the rack
6. Slide the GMA 35 unit out of the rack.
Reinstallation
1. Ensure that the audio panel circuit breaker is pulled and the GTN units are not receiving power.
2. Slide the GMA 35 straight into the rack until it stops.
3. Insert a 3/32" hex drive into the unit retention mechanism access hole at the bottom of the uni
t face
and turn the tool clockwise whi
le pressing on the
face of the unit until the GMA 35 is firmly seated
in the rack.
4.
Reinstall the GTN 7XX.
5. Verify that there are no failure messages or annunciations when the GTN and audio panel
is
po
wered on.
CAUTION
Be sure not to over tighten the unit into the rack. The application of hex drive tool torque
exceeding 15 in-lbs can damage the locking mechanism.