Filter
Top Products
190-01007-A1 System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
Rev. 7 Page 6-22
Figure 6-12. GPS/SBAS Antenna Cable Overbraid
#8 TERMINAL LUG
MS25036-156
OVERBRAID
AIRCRAFT SPRUCE P/N 863
NOTES:
THE OVERBRAID MUST BE INSERTED INTO THE GROUNDING LUG BY COMBING OUT AND
TWISTING THE WIRE STRANDS AND BEFORE TERMINATING THEM IN A TERMINAL LUG.
CABLE TIE DOWN
MS3367-1-X
3 PLCS
1.5"
OVERBRAID DOUBLED BACK
ON SELF
ANTENNA
CONNECTOR
1
TO GPS ANTENNA CONNECTOR
ON GTN BACKPLATE
OVERBRAID INTSTALLED OVER ENTIRE
LENGTH OF THE GPS ANTENNA CABLE
GPS/SBAS ANTENNA
2" MAX
WHEN REINSTALLING OVERBRAID AT CONNECTOR END OF PIGTAIL, THE OVERBRAID IS
PUSHED DOWN UNTIL IT TOUCHES THE TOP SURFACE OF THE CONNECTOR.
CONTINUE PUSHING BRAID DOWN BY SPREADING IT OUT ALONG THE TOP SURFACE
OF THE CONNECTOR. APPLY THE FIRST CABLE TIE AROUND THE BRAID AND ANTENNA
CABLE WHERE IT ENTERS THE CONNECTOR. THEN LIFT THE SPREAD PORTION OF
THE BRAID UP TO COVER THE FIRST CABLE TIE, DOUBLING BACK ON ITSELF. INSTALL
THE REMAINING TWO CABLE TIES ABOVE
THE BULGE CREATED BY THE FIRST CABLE
TIE WHICH IS NOW COVERED BY THE BRAID.
CONNECT TO P1001
SHIELD BLOCK
GROUND
2
2
1