Filter
Top Products
SECURlTi CODES
To Add a User
(continued)
-1
pgfq
& AUTHORITY LEVELS
Press 1 (YES) if this user will be allowed to am more than
one partition. Press 0 if this user will arm only his assigned
partition.
The keypad now prompts for the user’s access to the next
partition (see GOT0 command). Again press 0 or 1. If yes,
the system will automatically assign a user number for use in
that partition and will prompt for the authority level and global
arm option for this user within the partition.
When all partitions have been displayed, the keypad dis-
plays the partition(s) to which access has been assigned,
and displays the user number, authority level and global arm
option for each. The ‘G” after the authority level indicates
that the global arm feature is active for this user in the dis-
played partition. The ‘+I? indicates the partition from which
this user can be changed or deleted. The “.’ at the end of the
second line indicates that thii user sends open/close reports.
Open/close reporting is automatically active for any users
added by you, if you have open/close reporting active.
Limited Use User
(#84 Command)
To set the usage count for users with authority level 7, enter #84. The following
prompt appears.
Enter the number of times these users will have access to
the system. These codes automatically expire (but the
codes are not deleted) after this number of uses. To
reactivate the codes, simply enter #&I and set a new usage
limit
- 37 -