Filter
Top Products
SECURITY CODES & AUTHORITY LEVELS
General Rules
on Authority
Levels and
Changes
To Exit User Edit
Mode
A user may not delete or change the user code of the SAME or HIGHER authority than
which he is assigned.
A user may only ADD users to a LOWER authority level.
A user may assign access codes only to those partitions to which the user adding the
code has access. (ex. a user with access to only partition 1 cannot assign codes in
partition 2.)
The only way to assign a user’s authority level is by using the ‘Add A User’
procedure. To change a users authority level, that user must first be deleted, then
added again.
A user can only be DELETED or CHANGED from within the partition he is assigned.
User numbers must be entered as 2-digit entries. Single digit user numbers must be
;;;g;d by a “0” (example, 03, 04, etc.). Security codes are entered as 4-digit
Before assigning a security code, be sure it does not conflict with any DURESS code.
Note: When adding, changing or deleting users, all other alpha keypads in that partition
will display “User Edit Mode -
Please Stand By’, and key depressions (except
Panic) at those keypads will be ignored. Panic key depressions will cause an alarm and
terminate user entry.
You can exit any of the user edit modes described on the following pages at any time
by doing the following:
1. Press either
q
or I#I , or do not press any key for 10 seconds.
-
35
-