Filter
Top Products
SPECIAL SYSTEM FUNCTIONS
(USING #70 RELAY MENU MODE)
1170 Relay Menu
Your system may be set up so that certain lights or other devices can be turned on or off by
Mode
using the #70 command from either a keypad or a telephone keypad (if voice module is used).
Ask your installer if this has been done in your system.
To activate relays from a keypad, enter security code + [#] +70. Follow the prompts.
To activate relays using a telephone and voice podule, first dial the 2-digit phone
access code. When the system acknowledges the access, enter 4-digit security code + [#] +
70. The following prompts/voice responses will begin.
Voice:
“ENTER DEVICE CODE NOW
1
Enter the 2digit number of the device to be activated.
Note that if an invalid number is entered, the system will simply ask
YOU to reenter the number.
Voice:
‘voice descdptor DEVICE nn ON/OFF. FOR voice descriptorON
L
ENTER 1, FOR voice descriptor
OFF ENTER 0
1
Press 0 or 1 to turn the device off or on respectively.
‘nn’ represents
the 2-digit device
number and
voice descriptor is the relay
voice
descriptor programmed by the installer.
Voice:
‘voice descriptor DEVICE nn ON/OFF. TO EXIT ENTER 00 NOW
From a keypad, press $ to continue. The ENTER DEVICE NO.
prompt will appear.
From a telephone keypad, enter 00 to exit, or enter the next
relay number to be programmed. The current on/off state of that relay
will be annunciated as described above. Alternatively, if 6 seconds
elapses with no key depression, the voice module will annunciate the
‘ENTER DEVICE CODE NOW” message.
- 32 -