Filter
Top Products
TESTING THE SYSTEM
Testing Your 1. Open and close each protected door and window in turn and listen for three beeps.
System The identification of each faulted protection point should appear on the display.
2. Walk in front of any interior motion detectors (if used) and listen for three beeps as
movement is detected. The identification of the detector should appear on the
display when it is activated. The display will clear when no motion is detected. Note
that if wireless motion detectors are used, there is a 3-minute delay between
activation. This is to conserve battery life.
3. Follow the manufacturer’s instructions to test all smoke detectors to ensure that all are
functioning properly. The identification of each detector (or the zone number of the
zone assigned to the detector) should appear on the display when each is
activated.
4. When all protection points have been checked, there should be no zone
identification numbers displayed. If a problem is experienced with any protection
point (no confirming sounds, no display), CALL FOR SERVICE IMMEDIATELY.
5. Turn off Test mode by entering the security code and pressing the OFF key.
-
28
-