Filter
Top Products
SPECIAL SYSTEM FUNCTIONS
Executing Macros
Press and hold down (about 2 seconds) the “D” key until the following prompt appears:
I[
Enter your user code. The defined speed key sequence
will begin automatically.
NOTE: When defining speed key sequences, do not use the [#] key to represent Quick
Arming. The system uses the code entered at the prompt to initiate commands in a speed key
sequence, so quick an-n is unnecessary. The system interprets the use of the [#I] key in a speed
key sequence as its designated function only (usually installer functions).
Access Door Your system may be set up such that a locked access door (such as in a lobby) can be
Control
unlocked using a keypad command. Ask your installer if this has been done in your
system.
To activate this relay;
1. Enter your security code and press m.
The door will unlock for 2 seconds.
- 30 -