Filter
Top Products
7. SEWING
RH-981A
49
7-5. Setting the feed bracket to the front position
Setting the material will be easier if the feed bracket is moved forward from the standard cloth setting position.
Cycle time will be reduced with this setting, particularly if cutting after sewing is selected.
1. Turn off the power.
2. Set panel DIP switch No. 3 to ON.
3. Turn on the power and press the start switch (1).
* The feed bracket will move to the home position and then to the front position.
4. Sewing can then be carried out as normal. (Refer to “7-1. Automatic sewing”.)
7-6. Switching between single-pedal and dual-pedal operation
The work clamp can be lowered and the machine can start sewing just by pressing the start switch, without having to
use the cloth presser switch.
1. Turn off the power.
2. Change the setting of panel DIP switch No. 5.
OFF: To use both pedals (cloth presser switch and start switch)
ON: To use only one pedal (start switch)
3. Turn on the power and press the start switch (1).
* The feed bracket will move to the cloth setting position.
4. Sewing can then be carried out as normal. (Refer to “7-1. Automatic sewing”.)
Note:
During single pedal operation, when the start switch is pressed, the work clamp is lowered and sewing starts
straight away. If you would like to reset the material, set to dual-pedal operation.
2418Q
3141Q
2419Q
3141Q