Filter
Top Products
6. OPERATION
RH-981A
37
6-3. Program setting method
1. Press the SELECT key (1) to change the mode to
automatic, manual or test feed mode.
2. Press the and keys to select the program
number (1 - 9) for the independent program to be
changed.
Note: Program mode is not available if a cycle program
has been selected.
3. Press the SELECT key (1). The program mode
indicator (2) will illuminate.
* The parameter number "00" will appear in the
program number display (3), and the parameter
details will appear in the detail display (4).
4. Press the and keys to select the number of
the parameter to be changed.
5. Press the and keys to change the parameter
setting. (Refer to "Parameter table".)
* The flashing display indicates that the value has
not yet been accepted.
6. Press the ENTER key (5) to accept the changed
setting. (The display will then illuminate steadily.)
7. Repeat steps 4 to 6 to change other parameter
settings.
8. Press the SELECT key (1) to change the mode to
automatic mode.
* The program settings will be memorized.
6-3-1. Parameter table ( Taper bar )
The allowable setting range for some parameters may vary from the range specified, depending on the settings of
other parameters.
No. Setting items Setting range Unit Default
00 Sewing speed 1,000 - 2,200 rpm 100 1,800
01 Eyelet pattern 1 - 6 1 2
02 Button hole length (*1) -00: 5 - 50 mm
-01: 5 - 38 mm
-02 (L1): 14 - 18 mm
(L2): 18 - 22 mm
(L3): 22 - 26 mm
(L4): 26 - 30 mm
(L5): 28 - 32 mm
(L6): 32 - 36 mm
(L7): 36 - 40 mm
1 -00: 25 mm
-01: 25 mm
-02 (L1): 16 mm
(L2): 20 mm
(L3): 24 mm
(L4): 28 mm
(L5): 30 mm
(L6): 34 mm
(L7): 38 mm
03 Tacking length 0 - 20 mm 1 6
*1 The Button hole length setting value and the default value vary depending on the machine sub-class.
3051Q