Filter
Top Products
5. CORRECT USE
RH-981A
33
5-8
. Setting the installation position for cloth feed plate (L) (-52 specifications)
The installation position for cloth feed plate (L) can be set to one of four positions depending on the spacing between
buttonholes and the number of buttonholes to be sewn. When the spacing between buttonholes and the number of
buttonholes sewn have been changed, the installation position for cloth feed plate (L) should also be changed. Refer
to the illustration and table below at this time.
Install the cloth feed plate (L) (1) to the cloth feed bar (3) with the screws (2).
Installation position
<Standard specification>
Hole spacing
No. of holes
38.1 mm 44.45 mm 50.8 mm
3 (D) (D) (C)
4(C)(B)(A)
<Large size specification>
Hole spacing
No. of holes
38.1 mm 44.45 mm 50.8 mm 57.15 mm
3 (L) (K) (L) (L)
4 (L) (K) (J) (I)
5 (J) (I) (H) (F)
6(G)(F)(E)
(A) 207- 217 mm (E) 346.5 - 356.5 mm
(B) 192.5 - 202.5 mm (F) 321.5 - 331.5 mm
(C) 167.5 - 177.5 mm (G) 279.5 - 289.5 mm
(D) 142.5 - 152.5 mm (H) 270.5 - 280.5 mm
(I) 234.5 - 244.5 mm
(J) 209.5 - 219.5 mm
(K) 195 - 205 mm
(L) 184.5 - 194.5 mm
3046
Q
3045
Q
Standard Large size
0897Q