Filter
Top Products
3. INSTALLATION
RH-981A
13
3-12. Connecting the wiring
1. Pass the cable and air tube which are coming out of
the belt cover (1) and the machine head (2) through
the cable hole (3) in the work table.
2. Pass the cables and air tube which are coming out
of the feed bracket (4) and the left side of the bed
base (5) and the cable for the hand switch (6)
through the cable hole (7) in the work table.
Note: Leave enough looseness in the cables so
that they will not be pulled when the
machine head is tilted back.
Adjust the looseness after all connections to
the control box are complete.
3. Connect the hand switch connector (8) to the control
box connector.
4. Install the power switch (9) to the underside of the
work table with the two screws (10).
5. Secure the cables using staples (11) (in four
locations).
2994Q
3130Q
3131Q