Filter
Top Products
ICP-CC488 | Installation Guide | 22.0 Terminals and Descriptions EN | 94
Bosch Security Systems, Inc. | 12/08 | F01U089457-02
Table 64: Glossary (continued)
Term Description
lockout siren A siren that activates only once per zone per arming cycle.
master code A numeric code used for arming and disarming the system, and for allowing access to all
functions available through the codepad.
monitoring station A secure location where a digital receiver monitors a number of alarm systems and
deciphers their alarm transmission reports so the operator can advise the appropriate
authorities to take immediate action.
panic A condition or type of alarm in which the user requires either immediate police or
medical assistance.
partitioning Splitting a control panel into two separate controllable areas. Partitioning is useful for
securing sheds, dual occupancy dwellings, accessory dwellings, shops, and offices.
phone controller A device used to arm a security system over the telephone line, and to acknowledge
domestic alarm reports.
remote radio user
code
A code used to arm and disarm a system from a remote location, using hand-held
transmitters (in AWAY Mode or STAY Mode 1). Remote panic alarms are also allowed.
sealed Refers to a zone’s status. If a zone is sealed, the detection devices are not violated and
the zone indicator is not lit (that is, a reed switch is closed or a detector is on standby
waiting for an intrusion).
sensor watch A feature that allows the control panel to recognize when detection devices might have
stopped working. Sensor watch monitors the operation of a zone over a programmed
time period.
silent alarm An alarm that sounds only at a remote location, and gives no obvious local indication
that an alarm was sent out.
STAY Mode 1 A condition that automatically isolates certain zones when the security system is armed
in this mode. Only the installer can program these zones.
STAY Mode 2 A condition that automatically isolates certain zones when the security system is armed
in this mode. The Master Code holder can program these zones.
telco arming
sequence
A feature that automatically diverts a telephone number to another telephone when a
security system is armed in AWAY Mode, the same as using call forwarding.
telco disarming
sequence
An automatic suspension of diverting of the telephone when the system is disarmed.
unsealed Refers to a zone’s status. If a zone is unsealed, the detection devices are violated and
the zone indicator is lit (that is, a reed switch is open or a detector noted an intrusion).
user code A numeric code used to arm and disarm the system.
zone A monitored input used to activate an alarm. A zone might be set up to activate an alarm
only when the system is armed or to operate whether the system is armed or disarmed.