Filter
Top Products
ICP-CC488 | Installation Guide | 5.0 System Functions EN | 28
Bosch Security Systems, Inc. | 12/08 | F01U089457-02
Table 27: User Numbers Displayed by the
Codepad Indicators
User Zone Indicators
Number 1 2 3 4 5 6 7 8
1 X
2 X
3 X
4 X
5 X
6 X
7 X
8 X
Example
To delete user code number 3, enter:
[2 5 8 0 1][AWAY][3][AWAY][STAY]
5.2.3 Changing and Deleting Remote Radio
User Codes
This function allows a Master Code holder to change
or delete a remote radio User Code.
To add or change a remote radio User Code:
1. Enter your Master Code and press [1][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the number of the code (9 to 16) you want
to change and press [AWAY].
Two beeps sound and the corresponding
codepad indicators light. Refer to Table 28 on
page 28.
3. Enter the nine-digit RF ID number found on the
back of the hand-held transmitter and press [#].
Two beeps sound and the STAY and AWAY
indicators are extinguished.
4. Repeat this procedure to change other remote
radio User Codes.
This function is automatically terminated if
you do not press a button within 60 sec
or if you press [AWAY].
One long beep indicates that the code
already exists or you entered an incorrect
user number.
To delete a remote radio User Code:
1. Enter your Master Code and press [1][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the number of the code (9 to 16) you want
to delete and press [AWAY].
Two beeps sound and the corresponding
codepad indicators light. Refer to Table 28.
3. Press [STAY] to delete the User Code.
Two beeps sound and the STAY and AWAY
indicators are extinguished.
4. Repeat this procedure to delete other remote
radio User Codes.
This function terminates automatically if
you do not press a button within 60 sec
or if you press [AWAY].
One long beep indicates that the code
already exists or that you entered an
incorrect user number.
Table 28: Remote Radio Numbers Displayed
by the Codepad Indicators
User Zone Indicators MAINS
No 1 2 3 4 5 6 7 8 Indicator
9 X X
10 X
11 X X
12 X X
13 X X
14 X X
15 X X
16 X X
5.2.4 Changing Domestic Phone Numbers
When the system is set up for domestic dialing, this
function allows the installer to view and program the
telephone numbers the system calls if an alarm
occurs. Refer to Section 9.0 Domestic Dialing on page
42 for more information.
To change domestic phone numbers:
1. Enter you Master Code and press [2][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
If no telephone numbers are programmed, they
are displayed one digit at a time using the remote
codepad indicators. Refer to Table 30 on page 29
for the indicators and their meanings.
If no telephone numbers are programmed, an
additional two beeps sound after entering this
mode. These two beeps normally sound after
you enter the last digit of the last phone number.
2. Enter the first phone number.
Each digit is displayed as you enter it.
3. If you are programming another phone number,
press [STAY][4] to separate the end of one
phone number and the beginning of the next.
If you are not programming other numbers, go
to Step 5.
4. Repeat Steps 2 and 3 to program another phone
number.
5. Press [AWAY] to exit from this mode.