American Power Conversion Central Air Conditioning System Air Conditioner User Manual


 
2 NetworkAIR IR Operation, Maintenance, and Troubleshooting
Using the Display
The first time you apply power to the NetworkAIR IR In-row Precision Air Conditioner the display
initializes and runs an LED and alarm-tone test.
Scrolling status screens
After start-up, the interface displays the firmware revision number (if the fast start-up is disabled).
The display interface then scrolls automatically and continuously through nine screens of status
information.
Press the up or down arrow key to interrupt the automatic scrolling and view a specific status screen.
To return to the scrolling status screens, press the
ESC key from the main menu screen.
Status Screen Name Status Information Displayed
Control Temp & Humidity • Temperature and Humidity at the sensors being used to control
the environment
• Remote Temperature and Humidity (optional)
• Humidity Control Method (dew point or relative humidity)
Cool/Dehum Demands • Cool Demand %
Note: If you have more than one cooling coil (i.e., DX and
MultiCool), the demands are distributed between them.
• Dehumidify Demand %
• Actual Output %
Reheat Demand • Reheat Status: On/Off
(Steam, hot water, or hot gas only)
• Reheat Demand %
(Electric SCR only)
Humidify Demand • Humidify Demand %
Humidify Actual %
Group Status • Number of Systems
• Setpoint Share: On/Off
• Demand Fighting: On/Off
Group Status System number
•Role
State
Active Alarms • Alarm number
• Module identifier
•Alarm name
•Time stamp
Setpoints • Cool °C (or °F)
Reheat °C (or °F)
Setpoints • Dehumidify % RH
Humidify % RH