Filter
Top Products
Network Management Card: Quick Configuration
NetworkAIR IR Operation, Maintenance, and Troubleshooting 53
TCP/IP settings, select the Boot Mode menu. Select Manual boot mode, and then press ESC to
return to the
TCP/IP menu. (Changes will take effect when you log out.)
4. Set the System
IP, Subnet Mask, and Default Gateway address values.
5. Press
CTRL-C to exit to the Control Console menu.
6. Log out (option 4 in the Control Console menu).
Note
If you disconnected a cable during the procedure described in “Local access to the
control console” on page 51, reconnect that cable and restart the associated service.