Filter
Top Products
Operation: Respond to Alarms
NetworkAIR IR Operation, Maintenance, and Troubleshooting 39
Clear active alarms
Path: Main > Respond to Alarms > Clear Active Alarms
Clears all active alarms. If the conditions that caused the alarm still exist, those conditions cause the
alarm to be regenerated.
• Clear System Alarms — Clear active alarms that apply to the Modules in this System.
• Clear Group Alarms — Clear active alarms that apply to the Group.
Reset sys failure
Path: Main > Respond to Alarms > Reset Sys Failure
Reset a System after a failure event has occurred. If the condition that caused the failure still exists,
the System will fail again. A System will not restart after a failure until this command is executed.
Note
A System must be reset only if it is part of a Group. Stand-alone Systems will not go
into the failure state.