American Power Conversion Central Air Conditioning System Air Conditioner User Manual


 
NetworkAIR IR Operation, Maintenance, and Troubleshooting 47
Network Management Card
Quick Configuration
The NetworkAIR IR In-row Precision Air Conditioner is shipped with a Network Management Card
that provides for the management of the Air Conditioner over your network. You must set up the
Network Management Card in order to control the NetworkAIR IR In-row Precision Air Conditioner
through a web browser.
Overview
You must configure the following TCP/IP settings before the NetworkAIR IR In-row Air Conditioner
can operate on a network:
IP address of the Network Management Card
Subnet mask
Default gateway
Disregard the procedures in this section if you have APC InfraStruXure Manager
as part of your system. See the InfraStruXure Manager documentation for more
information.
Note
If a default gateway is unavailable, use the IP address of a computer that is located
on the same subnet as the Network Management Card and that is usually running.
The Network Management Card uses the default gateway to test the network when
traffic is very light.
See “Watchdog Features” in the “Introduction” of the User’s Guide for more
information about the watchdog role of the default gateway.