Filter
Top Products
Remote Operation Teledyne API – Technical Manual - Model 300E Family CO Analyzers
162
8.3. RS-485 CONFIGURATION OF COM2
As delivered from the factory, COM2 is configured for RS-232 communications. This port can be reconfigured
for operation as a non-isolated, half-duplex RS-485 port capable of supporting up to 32 instruments with a
maximum distance between the host and the furthest instrument being 4000 feet. If you require full duplex or
isolated operation, please contact Teledyne API’s Customer Service.
To reconfigure COM2 as an RS-485 port:
Locate J32 and move the shunt from Pins 1 2 to Pins 3 4.
Remove the connector from J12.
Plug the RS-485 connector into J15.
Figure 8-5: CPU RS-485 Setup
When COM2 is configured for RS-485 operation the port uses the same female DB-9 connector on the back of
the instrument as when COM2 is configured for RS-232 operation, however, the pin assignments are different.
04288D DCN5752