Filter
Top Products
Teledyne API – Technical Manual - Model 300E Family CO Analyzers Advanced Features
143
7.4.5. ADDING A RECORDER OFFSET TO AN ANALOG OUTPUT
Some analog signal recorders require that the zero signal is significantly different from the baseline of the
recorder in order to record slightly negative readings from noise around the zero point. This can be achieved in
the M300E/EM by defining a zero offset, a small voltage (e.g., 10% of span).
To add a zero offset to a specific analog output channel, select the ANALOG I/O CONFIGURATION submenu
(see Figure 7-4) then press:
04288D DCN5752