Filter
Top Products
Operating Instructions Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments 69
6.4. SETUP MODE
The SETUP mode contains a variety of choices that are used to configure the analyzer’s hardware and
software features, perform diagnostic procedures, gather information on the instruments performance and
configure or access data from the internal data acquisition system (DAS). For a visual representation of
the software menu trees, refer to Appendix A. The areas access under the Setup mode are:
Table 6-4: Primary Setup Mode Features and Functions
MODE OR
FEATURE
TOUCHSCREEN
BUTTON
DESCRIPTION
MANUAL
SECTION
Analyzer
Configuration
CFG
Lists key hardware and software configuration information 6.5
Auto Cal Feature
ACAL
Used to set up and operate the AutoCal feature.
Only appears if the analyzer has one of the internal valve
options installed
7.6
Internal Data
Acquisition (DAS)
DAS
Used to set up the DAS system and view recorded data 6.7
Analog Output
Reporting Range
Configuration
RNGE
Used to configure the output signals generated by the
instruments Analog outputs.
6.8
Calibration
Password Security
PASS
Turns the calibration password feature ON/OFF 6.9
Internal Clock
Configuration
CLK
Used to Set or adjust the instrument’s internal clock 6.10
Advanced SETUP
Features
MORE
This button accesses the instruments secondary setup menu
See
Table 6-5
Table 6-5: Secondary Setup Mode Features and Functions
MODE OR FEATURE
TOUCHSCREEN
BUTTON
DESCRIPTION
MANUAL
SECTION
External Communication
Channel Configuration
COMM
Used to set up and operate the analyzer’s various
external I/O channels including RS-232; RS-485,
modem communication and/or Ethernet access.
6.11 &
6.15
System Status Variables
VARS
Used to view various variables related to the
instruments current operational status
6.12
System Diagnostic Features
DIAG
Used to access a variety of functions that are used to
configure, test or diagnose problems with a variety of
the analyzer’s basic systems
6.13
CO
2
Concentration Alarms
ALRM
Used to activate the analyzer’s two gas concentration
status alarms and set the alarm limits
6.14
NOTE
Any changes made to a variable during one of the following procedures is not
acknowledged by the instrument until the ENTR button is pressed
If EXIT is pressed before the ENTR button, the analyzer will beep alerting the user
that the newly entered value has been lost.