Filter
Top Products
FAQ Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments 53
Remove the set screw located in the top, center of the rear panel
Remove the screws fastening the top cover to the unit (four per side).
Slide the cover back and lift straight up .
4. Disconnect the current loop option PCA from the appropriate connector on the motherboard (see
Figure 5-1).
5. Place a shunt between the leftmost two pins of the connector (see Figure 5-1).
6. Reattach the top case to the analyzer.
7. The analyzer is now ready to have a voltage-sensing, recording device attached to that output
5.3. Expendable Kits (Options 42C, 42D and 43)
OPTION NUMBER DESCRIPTION
OPT 42C
1 year’s supply of replacement of 47mm dia. particulate filters
OPT 42D 1 full replacement’s volume of indicating soda-lime for the external CO
2
scrubber
included with options 51 & 53 (approximate active lifetime: 1 year)
OPT 43
Options 42 C & 42D