Filter
Top Products
Pelco Manual C543M-A (7/03) 5
1.0 GENERAL
1.1 IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be
observed.
1. Installation and servicing should be done only by qualified service personnel
and conform to all local codes.
2. Unless the unit meets NEMA Type 3, 3R, 3S, 4, 4X, 6 or 6P standards, it is
designed for indoor use only and it must not be installed where exposed to
rain and moisture.
3. Only use replacement parts recommended by Pelco.
4. After replacement/repair of this unit’s electrical components, conduct a resis-
tance measurement between line and exposed parts to verify the exposed
parts have not been connected to line circuitry.
The product and/or manual may bear the following marks:
This symbol indicates that dangerous voltage constituting a
risk of electric shock is present within this unit.
This symbol indicates that there are important operating and
maintenance instructions in the literature accompanying this
unit.
CAUTION:
RISK OF
ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION:
TO REDUCE THE RISK OF ELECTRICAL SHOCK,
DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
Please thoroughly famil-
iarize yourself with the
information in this manual
prior to installation and
operation.
1.2 CERTIFICATIONS
The products identified below have been tested and certified for agency compli-
ance as noted.
Agency Compliance Certification
Model CE FCC UL cUL
CM9760-MXB X X X
CM9760-MXB-X X
Applicable CE, FCC, UL, and cUL directives/standards:
• 93/68/EEC–CE Mark Directive
89/336/EEC, 92/31/EEC–Electromagnetic Compatibility (EMC) Directives
• FCC–47 CFR, Part 15, Subpart B, Class A
NOTE:
This device complies with
part 15 of the FCC Rules. Opera-
tion is subject to the following two
conditions: (1) this device may not
cause harmful interference, and (2)
this device must accept any inter-
ference received, including interfer-
ence that may cause undesired
operation.
Radio and Television
Interference
This equipment has been tested
and found to comply with the limits
of a Class A digital device, pursu-
ant to part 15 of the FCC rules.
These limits are designed to pro-
vide reasonable protection against
harmful interference when the
equipment is operated in a com-
mercial environment. This equip-
ment generates, uses, and can
radiate radio frequency energy
and, if not installed and used in
accordance with the instruction
manual, may cause harmful inter-
ference to radio communications.
Operation of this equipment in a
residential area is likely to cause
harmful interference in which case
the user will be required to correct
the interference at his own ex-
pense.
NOTE:
The CM9760-MXBL does
not require power; therefore, certi-
fication is not required.