Filter
Top Products
Pelco Manual C543M-A (7/03) 33
3.2 CONNECTING POWER TO THE MATRIX BAY
The matrix bay is shipped from the factory configured for the correct input power.
The unit provides two separate power input receptacles, one for each power supply.
Each receptacle is equipped with its own On/Off switch and fuse assembly. In addi-
tion, each fuse assembly also provides a spare fuse. Refer to Figure 24. To remove
the fuse assembly, first remove the power cord from the receptacle and, using a
small screwdriver, pry the fuse holder out of the socket. The complete fuse assembly
comes out of the unit. Replace the fuse using a 1.6 ASB fuse. If using the spare,
make sure to replace the spare with one of the same rating.
WARNING:
Always
replace blown fuses
with fuses of the same
rating. Failure to do so
could result in serious
damage to the unit.
Figure 24. Replacing Power Supply Fuses
STORAGE DRAWER
FOR SPARE FUSE
REPLACE IF
NECESSARY
FUSE HOLDER