Filter
Top Products
Pelco Manual C543M-A (7/03) 25
Note the following about the termination jumpers on the RPC card:
• In a single-bay configuration (up to 256 cameras and 16 monitors), the jump-
ers on the RPC card must be set in the terminated position. Refer to Section
5.1 for an illustration of a single-bay configuration.
• In a downframe configuration, the jumpers on the RPC card must be set in the
unterminated position. Refer to Section 5.1 for information about downframing.
• In a sideframe configuration, the jumpers on the RPC card must be set in the
unterminated position. Refer to Section 5.2 for information about sideframing.
Where Is It Installed?
The Rear Panel Video Input Card is installed from the rear of the matrix bay in any
1 of 16 possible slot positions depending on your system configuration. Remember
that each RPC card is associated with a corresponding Video Input Card. Locate
the correct slot position and install the card as shown. Refer to Figure 17 for typical
installation geometry.
Figure 17. Installation of RPC Input Card