Automation (cont'd)
40
Updating Controllers (Keypads) with New or Removed devices
When devices are added or removed from the Z-Wave network, the device information needs to be updated in the Controllers. To
update this information you do not have to remove the device first. From the Primary controller, do the following:
ICON
ACTION
NOTES
1. Press Add on Primary controller.
2. Press Add on Secondary controller.
The controller scans for device changes.
The message is displayed: “Devices added Successfully”
Removing a Secondary Controller (Keypad)
To remove the Secondary controller, do the following:
ICON
ACTION
NOTES
1. At the Primary Controller keypad:
a) Press Delete.
2. At the Secondary Controller keypad:
a) Press Delete.
Both keypads will display, “Device Removed” and the Secondary Controller
keypad will revert back to the Primary Controller.
Z-Wave Troubleshooting
PROBLEM
SOLUTION
Cannot add new
device.
Make sure the Z-Wave device is within range of the Tuxedo Touch keypad. You may need to move the
device closer to the keypad. Refer to the Z-Wave device Instruction Guide for proper range.
Device is within
proper range but still
is not enrolled.
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the “Home” screen and then press the
Z-Wave Setup icon to display the “Z-Wave Device Management” screen.
b) If the device does not appear on the screen, press the Z-Wave Remove/Delete icon.
2. At the Z-Wave device, press the Function Key. The screen will display a message
“Device Removed”.
3. At the Tuxedo Touch Keypad:
a) Enroll device again.
Highlighted device
will not delete.
When deleting a device, if the selected device remains on the screen, highlight the device
name and press the Removed Failed Device icon.