Filter
Top Products
26
User Setup
User Setup allows you to Add a User, Delete a User, and Edit a User. You may access User Setup from the System Setup
screen. Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to various features and
functions. The keypad can hold the identity for 10 Users in its memory. If additional Users are needed, define the additional
Users using the Console Emulation Mode.
Users for the system are programmed in a central user setup location that provides the specific questions for authorization levels
assigned to different users. You may want these users to be the same, but there are situations in which you may want a user to
have limited capabilities. These capabilities are defined by the Authority Level assigned each user.
Authority Levels
Authority levels define the system functions a particular user can perform. Depending on the authority assigned to you, there are
certain system functions you may be prohibited from performing. The following information describes the authority levels that
can be assigned through the keypad and provides the equivalent authority level name found in your alarm system manuals. The
authority levels that can be assigned are as follows:
Authority
Level
Functions
Equivalent System Name
Residentia
l
Systems
Commercial
Systems
Master Can perform all security functions, add/delete users in assigned partition,
program scheduled events, and change partition master code
Partition Master Level 1 Master
Normal Perform security functions (arm, disarm) Standard User Level 3 Operator A
Guest Can arm the system in assigned partitions, but cannot disarm the system
unless the system was armed with this code.
Note: Do not assign this level if Quick Arm is enabled in your system.
Guest Level 4 Operator B
No
Access
Used to restrict access from a partition. N/A N/A
How to Add a User
ICON ACTION NOTES
1. From the "Home" screen, press the Setup icon.
2. Press the System Setup icon.
3. Press the USER SETUP icon.
4. Press the ADD USER icon and enter your Authorized
Code.
5. Press the Enter User Name field.
6. Type in the user name (6 characters max.; no spaces
between characters) and press the OK icon.
On the Data Entry screen, enter the user information.
• Use the Shift key for capital letters
• Use the BS (Backspace) key to make corrections.
• The @#$ key is not available for use at this time. These
characters cannot be saved to the control panel.