Filter
Top Products
72 www.honeywell.com
Configuring via WIN-PAK
Adding a New NetAXS™ Panel
10.Use the following procedure to reassign the interlocks:
a. Display the Readers tab, and then display the first input’s configuration window. Select
None, and click OK. This dissolves all input interlocks and changes the Shunt Time to 0.
This allows the input to be properly redefined for use with NetAXS.
b. Repeat the preceding step for each input for each reader on this tab.
c. After all interlocks on all inputs for each reader have been dissolved, reassign the
interlocks according to Table 3-1 below:
Table 3-1: Interlock Reassignments for NetAXS™
Interlock Function
1 Door egress for Door 1
2 Door status switch for Door 1. Shunt time is 15 seconds.
3 Door egress for Door 2.
4 Door status switch for Door 2. Shunt time is 15 seconds.
5 Door egress for Door 3.
6 Door status switch for Door 3. Shunt time is 15 seconds.
7 Door egress for Door 4.
8 Door status switch for Door 4. Shunt time is 15 seconds.
9 Reader 1 tamper/auxiliary.
10 Reader 2 tamper/auxiliary.
11 Reader 3 tamper/auxiliary.