Filter
Top Products
10 www.honeywell.com
Configuring via the Web Server
Configuring the System
2.1 Overview
This chapter explains the NetAXS™ configuration functions as accessed via the NetAXS™ web
server. These functions should be performed only by the NetAXS™ system administrator or service
personnel.
Caution: The sequence of NetAXS™ configuration tasks is critical. If the sequence given below is not
followed, the NetAXS™ system cannot be successfully configured.
The flow chart in Figure 2-1 shows the order in which to perform the administrative functions.
Figure 2-1: NetAXS™ System Configuration Flow Chart
Configure the Panel
Configuration > System > Host/Loop Communications (Host/Loop
Communications Tab, page 11)
Configuration > System > Network (Network Tab, page 20)
Configuration > System > General (General Tab, page 14)
Configuration > System > Site Codes (Site Codes Tab, page 21)
Configure the Time Zones
Configuration > Time Management > Time Zones (Time Zones Tab, page 26)
Configure the Access Levels
Configuration > Access Levels (Configuring Access Levels, page 45)
Assign Access Levels to Cards
Cards > Add Cards (Adding New Cards, page 47)
Configure the Doors
Configuration > Doors > Reader (Reader Tab, page 31)
Configuration > Doors > Output (Outputs Tab, page 38)
Configuration > Doors > Inputs (Inputs Tab, page 42)
Create the Cards
Cards > Add Cards (Adding New Cards, page 47)