Brother PR-650 Sewing Machine User Manual


 
EMBROIDERING TUTORIAL
——————————————————————————————————————————————————————————————
——
66
Resume sewing after the machine was turned
off
1
Press the start/stop button.
X The embroidery machine stops and the
start/stop button lights up in red.
The thread is not trimmed.
2
Touch to unlock the embroidery
machine.
3
Press the thread trimming button.
X The bobbin and upper threads are
trimmed.
Before turning off the embroidery machine,
be sure to trim the threads.
4
Set the main power switch to “{”.
X The embroidery machine is turned off and
the display and the start/stop button
indicator go off.
Sewing can resume after the embroidery
machine is turned on again. Back up
several stitches to overlap the stitching. For
details, refer to “Resume Embroidering
After Turning Off the Machine” on
page 110.
Memo
The machine can be stopped at any time,
even while it is embroidering; however, if
the machine is stopped when the thread
color is changed, it is not necessary to go
back through the stitching when
embroidering is continued. The machine
can be set to stop when the thread color is
changed. (For details, refer to “Specifying
pause locations before embroidering” on
page 128.)
If the thread breaks while sewing
If a problem occurs while sewing, such as if the
thread breaks, the machine stops automatically.
Re-thread the broken thread, back up several
stitches, and then continue sewing. For details,
refer to “If the Thread Breaks or the Bobbin
Thread Runs Out While Embroidering” on
page 105.