Filter
Top Products
Using the Settings Key 201
6
——
———————————————————————————————————————————————————————————————————
—
———————————————
Deleting short stitches
If embroidery data other than our original patterns
is used, the pitch may be too small, which may
result in the thread or the needle breaking. In order
to prevent this, the machine can be set to delete
stitches with a fine pitch. Stitches with a pitch less
than that specified here can be deleted.
When the embroidery machine is purchased, “0.3”
was selected (delete stitches with a pitch of 0.3
mm).
The setting to delete short stitches can be specified
from page 2/5 of the settings screen.
1
Touch and to select the pitch size.
The desired size is displayed.
• A value between 0 and 1 millimeters if the
units of measurements is set to “mm” (or a
value between 0 and 0.04 inch if the units
of measurements is set to “inch”) can be
specified.
Note
● If the setting is changed from the previous
setting, the new setting is only applied to
the next embroidery.
Specifying the remaining
length of thread
This setting specifies whether the length of upper
thread that remains threaded through the needle
after the thread is trimmed (length of thread passed
through the eye of the needle) has a standard tail or
long tail.
When the embroidery machine is purchased,
“Standard Tail” is selected.
The setting for the remaining length of thread can
be specified from page 2/5 of the settings screen.
1
Touch and to select the setting.
The desired length is displayed.
• If the machine misses stitches with a
standard length of thread after it is
trimmed, select “Long Tail”.
• When using metallic thread, select “Long
Tail”.
Changing the screen saver
settings
■ Specifying the length of time until the screen
saver is displayed
The screen saver is displayed when no machine
operation is performed for the specified length of
time.
A setting between “OFF” (0) and “60” minutes
can be set in 1-minute increments.
When the embroidery machine is purchased, “5
min” is selected.
The screen saver settings can be specified from
page 4/5 of the settings screen.