Filter
Top Products
Hooping the Fabric 67
3
Hooping the Fabric
Hooping the fabric in the extra-large
and large embroidery frames
1
Loosen the screw on the outer frame.
1 Screw
2
Place the fabric with right side up on top of
the outer frame.
• The outer frame does not have a front or
back side. Either side can be used as the
front.
3
Press the inner frame into the outer frame.
First insert the inner frame at the corner with
the screw A, next insert the nearby one corner
B, and then insert the opposite corner C.
Then insert the opposite corner of non screw
corner D.
First, align the inner and outer frames at the
corner with the screw A. Then, while lightly
pulling the fabric in the direction indicated by
arrow B so that the fabric is taut, insert the
inner frame at corner B. In the same way,
lightly pull the fabric in the direction indicated
by arrow C and insert corner C, and then
lightly pull the fabric in the direction indicated
by arrow D and insert corner D.
• Be sure that there are no wrinkles in the
fabric after it is stretched in the embroidery
frame.
4
While stretching the fabric even more,
securely tighten the screw so that the fabric is
taut.
• After stretching the fabric, lightly tapping it
should produce a drum-like sound.
• Firmly clamp together the inner and outer
frames so that their tops are even.
1 Outer frame
2 Inner frame
3 Right side of fabric
4 Top of inner & outer frames are even
• Using the included disc-shaped screwdriver,
firmly tighten the screw.
1 Disc-shaped screwdriver
Memo
● To correctly frame the fabric in the
embroidery frame, we recommend using a
flat surface.
1
1
4
3
2
1
Sapphire_brother.book Page 67 Thursday, November 17, 2005 2:48 PM