Filter
Top Products
Using the Optional Cap Frame 183
7
Note
● If the cap fabric is thick and the clamping
frame cannot be closed, or if the fabric is
thin and the cap is too loose within the
frame, loosen the screw for the inside
clamping frame, and then adjust the inside
clamping frame.
1 Inside clamping frame
2 Screw for the inside clamping frame
a
Pull the ends of the cap out from the center to
remove any slack.
b
Use the clips to secure the cap.
1 Clips
• Repeat steps a and b on the other side to
remove any slack and secure the cap with
the clips.
c
Pull the brim holder up as far as possible.
Next, turn the brim holder over the cap brim,
and then lower the brim holder. Finally,
arrange the brim so that it maintains a slightly
rounded shape.
1 Brim holder
2 Centerline of brim presser
• Make sure the notch comes out.
d
Adjust the brim so that it maintains a rounded
shape.
X This completes the positioning of the cap in
the advanced cap frame.
e
Remove the advanced cap frame from the
mounting jig.
Press both right and left holders on the
mounting jig with both thumbs, and then pull
off the embroidery frame, as shown in the
illustration.
1 Holder
1
1
1
Sapphire_chapt7.fm Page 183 Friday, November 18, 2005 12:10 PM