Brother PR-620 Sewing Machine User Manual


 
Troubleshooting 207
7
Error messages
If the start/stop button is pressed while the machine is not correctly set up or if an incorrect operation is
performed, the machine stops and informs you of the error with a buzzer and an error message. If an error
message appears, correct the problem according to the instructions in the message.
To close the message, touch or perform the correct operation, then touch . If the message
appears again, consult your nearest authorized dealer.
The pattern extends out of the
200 mm (H) × 300 mm (W)
embroidering area.
Move the pattern into the
embroidering area.
The installed embroidery frame
is too small.
Check which embroidery
frames can be used, and then
install a larger embroidery
frame. (Refer to page 28.)
There are too many characters
to be arranged on the curve.
Reduce the number of charac-
ters.
The upper thread was cut or
the thread came out the thread
tension disc or a thread guide.
The machine is not threaded
correctly.
Check that the thread is under
the upper and middle thread
guides and correctly thread the
upper thread.
(Refer to page 35.)
The bobbin thread was broken
or ran out.
Check that there is thread on
the bobbin and that approxi-
mately 50 mm (2 inches) of
thread has been pulled out, and
then re-install the bobbin.
(Refer to page 19.)
The machine couldn't delete
the data.
The media may be damaged.
Patterns on the embroidery
card cannot be read.
The embroidery card may be
damaged.
Characters have been com-
bined until they extend out of
the embroidery frame.
Decrease the number of charac-
ters so that they fit within the
embroidery frame.
Six manual needle bar settings
were being specified.
No more than five needle bars
can be specified.
Sapphire_chapt7.fm Page 207 Friday, November 18, 2005 12:10 PM