Filter
Top Products
APPENDIX —————————————————————————————————————————————————————————
—
172
3
Pass the machine bed through the ring of the
cap frame driver.
1 Machine bed
Note
● Be careful that the cap frame driver does not
hit any nearby parts, such as the presser
foot.
Attach the cap frame driver to the carriage as
described below in steps
4 through 6.
4
Insert the two thumb screws at the bottom of
the cap frame driver into the v-cuts in the
carriage, and then place the mounting plate of
the cap frame driver on top of the frame-
mounting plate of the carriage.
1 Notch in the carriage
2 Thumb screw of the cap frame driver
3 Mounting plate of the cap frame driver
4 Frame-mounting plate of the carriage
5
Insert the pins on the frame-mounting plate of
the carriage into the holes in the mounting
plate of the cap frame driver.
1 Pins on the frame-mounting plate of the carriage
2 Holes in the mounting plate of the cap frame
driver
6
Insert and tighten the two upper thumb
screws in outer holes of mounting plate of cap
frame driver.
7
While pushing in the cap frame driver toward
the machine so that it is fully inserted, tighten
the two lower thumb screws to secure the cap
frame driver.
X This completes the installation of the cap
frame driver.
1
3
4
1
2
1
2
Sapphire_chapt7.fm Page 172 Friday, November 18, 2005 12:10 PM