Filter
Top Products
EMBROIDERING TUTORIAL ——————————————————————————————————————————————————
—
40
3
Pass the thread under the guide on the presser
foot.
1 Guide on presser foot
2 Notch in guide on presser foot
• Make sure that the thread securely passes
through the notch in the guide on the presser
foot.
4
Securely pass the thread through the groove
in the thread cutter, and then lightly pull the
thread to cut it.
1 Groove in thread cutter
Note
● If the thread is not correctly passed through
the groove in the thread cutter, the message
“Wiper error.” appears and the needle
cannot be threaded. Be sure to securely pass
the thread through the groove.
● If enough thread is not pulled out, the
thread cannot be pulled through the thread
cutter.
5
Press the automatic needle-threading button.
• The threader moves back away from the
needle. The thread is pulled through the
needle eye.
• The wiper comes out and catches the thread
between the needle and the threader.
• The threader goes back to the original home
position.
This completes the upper threading for needle
bar 1.
Thread the remaining needle bars in the same
way. However, if the needle bar to be threaded
is not moved to the embroidery position, the
needle cannot be threaded with the automatic
needle-threading mechanism. For the
remaining needle bars, perform the following
operation to move the needle bar to the
embroidery position before trying to thread the
needle.
■ Moving the needle bar to be threaded to the
sewing position
1
Touch the key for the needle bar that you wish
to thread.
X The selected needle bar moves to the
embroidery position.
2
1
1
Sapphire_brother.book Page 40 Thursday, November 17, 2005 2:48 PM