Filter
Top Products
Start-up Procedure
-69-
Fix the Wire Harnesses
Step 5: Using the included wire holders, fix the wire harnesses to the water heater jacket only to the left of
the water heater gas control, as shown in Figure 106. Wire holders can be used to fix the wire harnesses
to the water heater jacket only to the left of the water heater gas control.
Route Transformer Wire Harness
Step 6: Route the Transformer wire harness, so it is not in trip contact or touching the floor between the
water heater and dam. This is shown in Figure 107.
Fi
g
ure 106
Figure 107
Use Wire Holders
to the Left of this
Line Only
Wire Holders
Wire Harnesses
Transformer
Transformer Wire
Harness
WARNING
Failure to properly located the Transformer Wire Harness will result in a trip hazard or potential
electrical hazard.