Filter
Top Products
Setback Control Installation
-33-
Install the Setback Control
Step 13: Snap the Setback Control into the backplate on the Setback Control Junction Box Assembly.
Align the Setback Control to the backplate, and press until it is fully seated. This is shown in Figure 40.
Connect the Setback Control Wire Harness to the Setback Control Junction Box Assembly
Step 14: Take the plastic connector end of the Setback Control wire harness, and connect it to its
connector mate in the back of the Setback Control Junction Box Assembly. This is shown in Figure 41.
Figure 40
Figure 41
Setback Control
Junction Box Assembly
Top of Water
Heater
Backplate Already
Installed
Setback
Control
Top of Water
Heater
Setback Control Junction
Box Assembly
Setback Control
Wire Harness
Connector
Mate