Filter
Top Products
Leak Sensor Installation
-48-
Position the Dam
Step 17: Position the dam around the water heater, so it surrounds the water heater and corrals a water
heater tank leak towards the Leak Sensor. This is shown in Figure 68.
Fill in the Gaps
Step 18: Fill in any gaps between the dam and the floor. This is shown in Figure 69.
The Leak Sensor installation is complete. Proceed to the installation
sections for the other purchased packages. Or, if finished, proceed to
the Start-up Procedure on page 67.
Figure 68
Fi
g
ure 69
Dam
Leak Sensor
Caulk Gun with
RTV Silicone
Fill Gaps
between Floor
and Dam
WARNING
The dam must be mounted against the floor or it will not hold any water.