Filter
Top Products
Setback Control Installation
-32-
Position the Setback Control Junction Box Assembly
Step 11: Put the Setback Control Junction Box Assembly back on top of the water heater and position it to
the pre-drilled holes. This is shown in Figure 38.
Mount the Setback Control Junction Box Assembly
Step 12: Using (2) of the included Philips head screws, screw the Setback Control Junction Box Assembly
to the top of the water heater, as shown in Figure 39.
Figure 38
Figure 39
Setback Control
Junction Box Assembly
Top of Water
Heater
Top of Water
Heater
Setback Control
Junction Box Assembly
Philips head
screwdriver
WARNING
Do not mount the Setback Control Junction Box Assembly close to the draft hood. Position this
assembly as close to the front of the water heater as possible.