Filter
Top Products
Leak Sensor Installation
-45-
Position the Leak Sensor
Step 11: Position the Leak Sensor up against the water heater jacket, as shown in Figure 62. The Leak
Sensor must be positioned to the left of the water heater gas control. The Leak Sensor must sit flat on the
floor or in the drain pan.
Mark the Location of the Leak Sensor
Step 12: Using a marker, mark the location of the hole in the Leak Sensor bracket, as shown in Figure 63.
Figure 62
Fi
g
ure 63
Leak Sensor
Position the Leak Sensor 3” from the Air Slots or
if not Present, Position it 6” from the Doorway
Leak Sensor
Bracket
Marker
Leak Sensor
Wire Harness
CAUTION
The water heater must be installed on a level floor.
WARNING
The Leak Sensor can be mounted in a water heater drain pan. If the installation does not use a
drain pan, the dam should be used to corral the water heater tank leak to the Leak Sensor.
The bottom of the Leak Sensor must be touching the floor. Failure to do so will result in
inaccurate leak detection.
Doorway
Air Slots